Select a Community
Are you sure you want to trigger topic in your Anconeus AI algorithm?
You are done for today with this topic.
Would you like to start learning session with this topic items scheduled for future?
Osteolysis and subsequent component loosening will be minimal if the wear rate continues
67%
2571/3818
Osteolysis and subsequent component loosening will be greater than conventional hip arthroplasty if the wear rate continues
24%
908/3818
Component positioning should have no effect on wear rates of these bearings
7%
259/3818
All total hip arthroplasties should use this new polyethylene
1%
36/3818
Patient satisfaction will be greater at 10 year follow up
22/3818
Select Answer to see Preferred Response
Polyethylene wear rates have shown association with osteolysis and subsequent component loosening. Wear rates above 0.1 mm per year are at significant risk of osteolysis. Dumbleton et al performed a meta-analysis of the literature concerning wear rates and osteolysis. They concluded that osteolysis was rarely observed when the wear rate was less than 0.1 mm per year. Sakalkale et al reported on 10 year follow up of 60 total hips performed with a cementless, tapered, circumferentially coated femoral stem. They reported no osteolysis of the femoral component even though there was a high incidence of acetabular osteolysis. Sochart et al reviewed 235 total hip arthroplasties performed by Charnley with 20 year follow-up. Osteolysis and revision was significantly associated with polyethylene wear rates. Average wear rates for hips that did not go on to revision was 0.09 mm per year compared to 0.19 mm per year for hips that were subsequently revised for loosening.
2.9
(39)
Please Login to add comment